Overrunning Clutch Bearing RSCI 180-300

Overrunning Clutch Bearings Features

Primarily designed as a backstop, this type can be also used as an overrunning clutch in crawl drives, where the overrunning speed is high but the driving speed is low and does not exceed the maximum driving speed shown in the table. Centering of the outer race must use the inner bore.The centering spigot must not contact the sprag cage. Please refer to page 76 (RSCI 20-130) for further information.

NOTES

1) T max = 2 × T KN

2) This maximum allowable torque transmission speed n max must not be exceeded when transmitting torque

3) This minimum allowable overrunning speed ni imin should not be reduced under continuous operation.

Possible reduction of this minimum speed on request

4) Inner race overruns Keyway to DIN 6885.1

5) Tolerance +1 Cover F8 must be ordered seperately. Other bore diameters on request

MOUNTING EXAMPLE